I guess I learned a few things about my POTA setup and a few changes that need to be made.

First, these battery packs I am currently using don't last long at all. I've decided to purchase another of the small blue lithium packs like I use with the KX3. The only problem there is that I will have to build an adapter cable as they come with a 3.5mm plug, while the QMX uses a 2.1mm plug. I have plenty of 2.1mm plugs and I have an old battery that bulged and is no longer usable. I'll scavenge the 3.5mm charging socket off of that, solder on a 2.1mm plug and I'll have the adapter cable I'll need.

Second, I'm not thrilled with the paddle I had recently purchased.  I'm having a hard time adjusting it to the feel that I want, and as I was putting it back into the QMX bag yesterday after the Kring Point activation, a small nut dropped out of it and landed on the picnic tabel - not good. I still have a Whiterook single lever paddle kicking around somewhere and I also have the Bulldog Clip key. I can use either one of those. My American Morse DCP paddle will remain exclusively with the KX3.

Lastly, I have not fallen in love with the QMX to the point to replace my KX3 with it. For POTA activations, it's great because you generally find a clear frequency, call "CQ POTA" and don't move around too much. The KX3 is way more easier to tune. For general operating, and for hunting and pouncing in Sprints the KX3 is the way to go. Plus the KX3 gives me access to bands that the QMX does not. The QMX will be my "in the car, operate at the spur of a moment" rig. The KX3 will remain the weapon of choice for serious operating. 

72 de Larry W2LJ

QRP - When you care to send the very least!

It was a great time being back in Ottawa, visiting with friends from my old neighborhood and also spoiling my Daughters two cats.

However on the “Radio side” of things …. not so good

The plans were that I would be able (weather permitting) continue to control my hour on the Trans Provincial Net while away. It seemed that “Mother Nature” had different ideas. Most days rain or the threat of rain kept me from heading over to the park.

Above pic showing where the park was and the route I took

As I mentioned in a previous post…. there was a local (non-POTA) park within walking distance to operate from. It was a local sports field and had some bleachers for when the crowds came for Junior Soccer/Football and or Rugby…

Below pic showing how I set up at the park

Although the operating position was excellent there was NO PROTECTION from the elements which in my case meant rain.

I was able to wrap my MFJ mast to one of the bleachers and stretch the end of the EFHW antenna to the other bleacher and it did work like a charm. Signal reports were great considering I was running 50w into the antenna

So for 1 out of a potential 5 operating days it was fun and dry. Walking home with the gear safely packed in the backpack “Mother Nature” paid a short visit.

I also managed to activate CA1515 and CA1516 using my Xiegu X5105 along with a 29 foot wire (supported by the same mast mentioned earlier) with a 9:1 unun, a 17 foot counterpoise with a choke on the radio end of the coax. Jose VA3PCJ was nice enough to offer me a ride there and back. I activated the parks using SSB and VA3PCJ activated the same parks using CW and his KX3.

For Jose’s version of the park activation click HERE

I am expecting to be returning to Ottawa in Mid-January 2025 for another visit with my GrandKits and like last years winter visit there will be a car to keep me warm and dry.

73bob

It was a great time being back in Ottawa, visiting with friends from my old neighborhood and also spoiling my Daughters two cats.

However on the “Radio side” of things …. not so good

The plans were that I would be able (weather permitting) continue to control my hour on the Trans Provincial Net while away. It seemed that “Mother Nature” had different ideas. Most days rain or the threat of rain kept me from heading over to the park.

Above pic showing where the park was and the route I took

As I mentioned in a previous post…. there was a local (non-POTA) park within walking distance to operate from. It was a local sports field and had some bleachers for when the crowds came for Junior Soccer/Football and or Rugby…

Below pic showing how I set up at the park

Although the operating position was excellent there was NO PROTECTION from the elements which in my case meant rain.

I was able to wrap my MFJ mast to one of the bleachers and stretch the end of the EFHW antenna to the other bleacher and it did work like a charm. Signal reports were great considering I was running 50w into the antenna

So for 1 out of a potential 5 operating days it was fun and dry. Walking home with the gear safely packed in the backpack “Mother Nature” paid a short visit.

I also managed to activate CA1515 and CA1516 using my Xiegu X5105 along with a 29 foot wire (supported by the same mast mentioned earlier) with a 9:1 unun, a 17 foot counterpoise with a choke on the radio end of the coax. Jose VA3PCJ was nice enough to offer me a ride there and back. I activated the parks using SSB and VA3PCJ activated the same parks using CW and his KX3.

For Jose’s version of the park activation click HERE

I am expecting to be returning to Ottawa in Mid-January 2025 for another visit with my GrandKits and like last years winter visit there will be a car to keep me warm and dry.

73bob

Today I found about a new Rig coming out (early 2025??) by Yaesu.

Now if you follow this link it will take you to the ML & S website which is where I got the information.

Just give it a good look over…. They did the work so it seems only fair that you read up on it from their site…

Now here are some of my early comments….

From what I have read (and the way I see it) the new Yaesu FTX1F will be in direct competition with the Elecraft KX3 along with the Icom IC705.

I’m guessing that it will also be close in price with Icom and Elecraft.

However that expected price point will keep it out of my backpack. Although I am a BIG FAN of the Yaesu brand. I have 3 (FT991a, FT891 and FT2dr) of them in the shack right now.

I just can’t justify any radio costing approx $2000.00 CDN going out with me into the field where it can easily get damaged.

If (when)I buy one it will be sitting on my desk beside the Yaesu FT991a that is working great for me.

I have very well used Xiegu X5105 that works well for me in the field. If it was to fall off the picnic table or get damaged in any other way I will be out about 25% of the expected price of the FTx1F.

Guessing that there will be more info coming out in time for the Hamcation in Florida along with Hamvention in May.

I’m looking forward to seeing a North American Price…

Then all I have to do is convince Liz we need one.

73bob

Today I found about a new Rig coming out (early 2025??) by Yaesu.

Now if you follow this link it will take you to the ML & S website which is where I got the information.

Just give it a good look over…. They did the work so it seems only fair that you read up on it from their site…

Now here are some of my early comments….

From what I have read (and the way I see it) the new Yaesu FTX1F will be in direct competition with the Elecraft KX3 along with the Icom IC705.

I’m guessing that it will also be close in price with Icom and Elecraft.

However that expected price point will keep it out of my backpack. Although I am a BIG FAN of the Yaesu brand. I have 3 (FT991a, FT891 and FT2dr) of them in the shack right now.

I just can’t justify any radio costing approx $2000.00 CDN going out with me into the field where it can easily get damaged.

If (when)I buy one it will be sitting on my desk beside the Yaesu FT991a that is working great for me.

I have very well used Xiegu X5105 that works well for me in the field. If it was to fall off the picnic table or get damaged in any other way I will be out about 25% of the expected price of the FTx1F.

Guessing that there will be more info coming out in time for the Hamcation in Florida along with Hamvention in May.

I’m looking forward to seeing a North American Price…

Then all I have to do is convince Liz we need one.

73bob